Xiaomi 70mai Jump Starter PS02 Power Bank

70mai Jump Starter PS02 Power Bank
Real 11000mah Car Starter Auto Buster Car Emergency Booster Battery

Xiaomi 70mai Jump Starter 70Mai Car Jump Starter Battery Power Bank Cars Starter Auto Buster Car Emergency Booster Engine Start

Feature and Specification

1.Multifunctional Power Bank:

-Our jump starter is very smart and multifunctional, built in a 5V/2.4A USB charging port and LED flashlight. USB output charging port

-can be used to charge mobile phone, tablet, camera and so on, it’s very necessary when your electronic equipment is dead. Whether

-you need light to change a tire, inspect an engine, or need to warn oncoming traffic that you are broken down on the -roadside, the ultra-bright flashlight have you covered, and it has three lighting modes: lighting, SOS, flash.

2.Built-in LED battery Indicator Light, Waterproof and fireproof design:4 small led battery indicator lights to show the remaining battery, smooth surface without leaving fingerprints, fire-proof and waterproof material design,

3.Temperature Protection and Smart Clamps:

-Temperature protection design provides full protection to ensure the safety of usage from overheating.

-Eight protection smart clamp: Short-circuit protection, Over-voltage protection, Over-current protection, Over-charge protection,

-High-temperature protection, Reverse connect protection, Over-discharge protection, Reverse filling protection.

How to use the 70mai Jump Starter? Using the device as a 12V jump starter

1. Connect the jump starter to the device. Ensure that the indicator on the battery clips are off.

2. Connect the battery clips correctly to the positive and negative ends of the car battery. The red clip should be connected to the positive (+) end, whilethe black clip should be connected to the negative (-) end. Then, follow the instructions below:

1. When the green light is turned on, the connection is correct and the battery can be jump started.
2. When the red light is turned on and a buzzer sound can be heard, the clips are connected to the wrong ends. Connect the clips correctly and make sure the green light is turned on before jump starting the battery.
3. When the green light is flickering and a buzzer sound can be heard, the voltage is too low. Press the boost button and wait till the green light stops flickering. Jump start the battery within 30 seconds.
4. When both the green and red lights are not turned on and no buzzer sound can be heard, the battery may be completed damaged. Ensure that the clips are connected to the correct ends. Press the boost button and wait till thegreen light is turned on. Jump start the battery within 30 seconds.

3. After the car is jump started, remove the battery clips.

Independent lighting switch,you can change it into lighting ,Strobe lighting and SOS signal light by one switch.

In full charged status,you can use highlight lighting continuously for 48 hours.Help you handle emergency situation freely when equipped your car with it.

DO Anti-reverse interface design,can be recognized automatically when battery clip is being reversed,avoiding wrong operation.

An overall easy-to-use jump starter that’s ideal for any newbie.Connect your portable jump starter, start your car, disconnect the jump starter, and then leave. Don’t wait for someone to save you, take care of it yourself and leave.

Basically the same size as a portable power bank for smartphones

Cellphone will always have 4% battery power when you need them most. A good reason to keep a power pack jump starter in your car is that most will have a USB port on them that you can use to charge your phone. You can also use it to charge a tablet and anything else that gets it’s charge through a USB chord.

Basic Parameters

1. Dimensions: 163×87×27mm
2. Capacity: 11100mAh(41.07Wh)
3. Output: 5V / 2.4A,12V jump starter port
4. Input: 5V / 2A
5. Charging time: ≤5.5hours
6. Jump start current: 250A
7. Peak current: 600A
8. Operating temperature: -20℃~55℃
9. Charging temperature: 0~55℃
10.